2 way switch (3 wire system, old cable colour...

Here we a have a schematic (Fig 1) which makes it easy to visualise how this circuit works. In this state the lamp is off, changing the position of either switch will switch the live to the lamp turning it on. If you now change the position of the other switch the circuit is broken once again.

Fig 1: Two way switching schematic wiring diagram (3 wire control)

The schematic is nice and simple to visualise the principal of how this works but is little help when it coms to actually wiring this up in real life!!

Fig 2 below shows how we achieve this configuration. Just like anyloop-in loop-out radial circuit, the switch cable from the ceiling rose contains two wires, a permanent live and a switched live. This is cable C below, one wire connects to L1 and the other to L2 on the top switch.

Cable D (Fig 2) is athree core and earth, this is the ’3 wire control’ that links the two light switches together. COM on the first switch connects to COM on the second switch, L1 on the first switch connects to L1 on the second, and L2 on the first switch connects to L2 on the second.

All earth wires should connect to the earth terminal in the switch back-box and if you are using metal switches there MUST be a loop from this earth terminal to the one on the switch plate (see note A on Fig 2)

Fig 2: Two way switching using a 3 wire control (shown in the old cable colours)

NOTE: The blue and yellow wires in cable ‘D’ and the black wire in cable ‘C’ are switched lives and thus should be marked with red sheathing at each end as shown.

Switch drops from a junction box

There is a chance that if your house has these old wiring colours the switch drops may be from aloop-in-loop-out radial lighting circuit done with junction boxes rather than ceiling roses as shown in Fig 2. The switch wiring is all the same but the switch wire (cable C) leads up to a different set up.

Fig 3: 3 way switching wired to a loop-in-loop-out radial lighting circuit done with junction boxes